Installation, replacement and cleaning of industrial rubber roller

During the embossing process, many friends have encountered the problem that the machine cannot operate normally due to improper installation and maintenance of the embossing rubber roller. Therefore, how to install, replace and clean correctly.

1. Installation of embossing rubber roller

a. Select the pressing roller according to the width of the printing material;

b. Clean the selected pressure roller on the rack with the grinding step and solvent;

c. Touch the surface of the pressure roller quickly and laterally by hand to check the flatness of the surface of the pressure roller;

d. The two work together to lift the qualified pressure roller, transport it to the installed color base, install it to the concave card position of the fixing frame, and tighten the fixing screws.

Matters needing attention1:

a. The width of the pressing roller shall be less than the width of the printing material

b. It is found that the pressure roller is uneven, severely expanded, cracked, and the bearing is necrotic. It cannot be used on the machine.

c. During installation, it is strictly prohibited to collide and scratch the surface of the drum.

2. Replacement and cleaning of embossing roller

a. Loosen the fixing screws at both ends of the pressure roller together;

b. Grasp the two shaft ends of the pressure roller by hand, pull out the pressure roller, lift it, transport it to the pressure roller placement area, and place the pressure roller on the storage rack;

c. Clean the removed pressure roller with a clean soft cloth and solvent.

Matters needing attention2:

a. If the surface is deformed or damaged and cannot be used, it shall be marked clearly and reworked in time.

b. During the removal process, it is strictly prohibited to collide, scratch and damage the surface of the pressing roller.